全國熱線服務:
新聞資訊 Top label
- The Complete Guide to Pressure Sensors: Technology, Applications, and Selection Criteria
- The Evolution and Advantages of Electro-Hydraulic Synchronous Press Brakes in Modern Manufacturing
- Revolutionizing Semiconductor Manufacturing: The Role of Electrostatic Chucks in Modern Wafer Processing
- What Is A Humidity Sensor? How Does It Affect Our Lives And Work?
- The Essential Guide to Modern Bending Machines: Technology, Applications, and Selection Criteria
- The Complete Guide to Modern Hospital Beds: Transforming Patient Care Through Advanced Design
A brief analysis of the reasons why piston rods are often damaged
1. It is possible that the process gas contains a large amount of liquid, which causes the impact of the piston rod and the cylinder fluid, causing it to be broken at the dead center gap.
2. The design of the piston rod's buffer, cylinder and cylinder seat is very unreasonable. It may be that the position of the buffer is relatively far from the cylinder, causing the exhaust gas to not be buffered as it should be. As a result, the cylinder begins to vibrate, along with the piston rod. At this time, the concentricity of the piston rod and the crosshead deviates.
3. When installing the cylinder and the middle body, the concentricity did not meet the specified standards, resulting in an angle between the middle lines of the cylinder and the middle body. The piston rod and crosshead can easily cause bending stress during operation.
4. When processing the piston rod thread, the bottom angle of the thread should be set relatively small.
Please indicate the source when reprinting:http://m.cbtea.cn
2. The design of the piston rod's buffer, cylinder and cylinder seat is very unreasonable. It may be that the position of the buffer is relatively far from the cylinder, causing the exhaust gas to not be buffered as it should be. As a result, the cylinder begins to vibrate, along with the piston rod. At this time, the concentricity of the piston rod and the crosshead deviates.
3. When installing the cylinder and the middle body, the concentricity did not meet the specified standards, resulting in an angle between the middle lines of the cylinder and the middle body. The piston rod and crosshead can easily cause bending stress during operation.
4. When processing the piston rod thread, the bottom angle of the thread should be set relatively small.
Please indicate the source when reprinting:http://m.cbtea.cn